CROSSING SIGNALS BY PROGRAM CONTROLLED BOAT
DESCRIPTION:
Design and build an intersection where traffic is regulated by two traffic lights with three lights (red, yellow and green) and buzzer for each blind.
This boat using a program which will turn one revolution per minute, so that the lights cycle through the three lights and the buzzer in that minute. Therefore we will perform the necessary calculations to determine the times of on and off every light, and therefore necessary to place duct tape over the boat programmer.
To move the programmer can use a motor of 414 rpm, so you need to calculate, design and construct a motion reducing system of pulleys, gears or worm - crown.
The project will be built on a wooden platform, where they differentiate two distinct parts: Intersection of streets with traffic lights and reduction system.
The project will have a switch to disconnect, because if you do not have, there are always some light on.
used where possible recycled, refurbished or reused.
DOCUMENTATION:
Each group must provide documentation that has been given, with every piece of data that are requested: Sketch
individual.
distribution of work and responsibilities.
Sketch of the solution group. Sheet
processes.
budget sheet.
Incidents sheet. Sheet
self.
Technical Project: Reports, Calculations, Plans and Budget.
Cover Sheet and qualification.
DEADLINE: APRIL 16
